Piston Oil Nozzle Installation
WARNING: This page is about a different variant/trim than selected.
- CAUTION:
The piston oil cooling nozzle must be aligned to direct oil towards the oil inlet hole on the bottom of the piston. Improper alignment of the piston oil cooling nozzle will allow insufficient oil lubrication to the piston and cause severe engine damage.
Install the piston oil cooling nozzles (1).
- Install the piston oil cooling nozzle bolt (2) and tighten to 11 N.m (97 lb in).
CAUTION:
Refer to Fastener Caution .