Fuel Injection Pump Drive Pulley Removal
WARNING: This page is about a different variant/trim than selected.
Special Tools
- EN-51104
Injection Pump Sprocket Holder
- DT-22888 - 20A
Universal Two Jaw Puller
For equivalent regional tools, refer to Special Tools
 Courtesy of GENERAL MOTORS COMPANY
|
Hold the fuel injection pump drive pulley (1) with the EN-51104
holder and loosen the retaining nut.
 Courtesy of GENERAL MOTORS COMPANY
|
Remove the fuel injection pump drive pulley nut (1) and pulley (2) using the DT-22888 - 20A
Universal Two Jaw Puller.