Crankshaft Rear Oil Seal Housing Removal

Special Tools

• EN-50026  Rear Main Seal Installer
• GE-8092  Driver Handle

For equivalent regional tools, refer to Special Tools 

1. Courtesy of GENERAL MOTORS COMPANY

   Remove the crankshaft position sensor excitor ring (1) and locating pin (6).

2. Remove the rear oil seal housing bolts (2) and seal housing (3).
3. Remove the rear oil seal housing gasket (4).
4. Remove the rear oil seal housing locating pins (5).

5. Courtesy of GENERAL MOTORS COMPANY

   NOTE:

   The crankshaft rear oil seal must be driven out from the engine block side of the housing.

   Remove the crankshaft rear oil seal (1) using the EN-50026  installer (2) and GE-8092  handle (3).