Installation Procedure
WARNING: This page is about a different variant/trim than selected.
Camshaft Timing Pulley (2) - Install
- Camshaft Gear Bolt (1) - Loosely install
- NOTE:
The EN-51025 wrench holding tool is installed during timing belt removal and installation but should NOT be used to hold the camshaft during camshaft gear bolt tightening. Always use the EN-50025 wrench to hold the camshaft timing pulley during tightening.
Counter hold the camshaft timing pulley (1) using the EN-50025 wrench (2).
- Camshaft Gear Bolt (3) - Install - Camshaft Timing Pulley Installation
- Timing Belt - Install - Timing Belt Replacement