Automatic Transmission Flex Plate Removal

WARNING: This page is about a different variant/trim than selected.

Special Tools

EN-51265 Crankshaft Locking Tool

For equivalent regional tools, refer to Special Tools

Courtesy of GENERAL MOTORS COMPANY

Ensure that the timing mark on the crankshaft timing pulley (1) is aligned at 90 degrees ATDC with the mark on the front cover (1).
Courtesy of GENERAL MOTORS COMPANY

Install the EN-51265 locking tool.
Courtesy of GENERAL MOTORS COMPANY

Remove the flexplate bolts (1) and flexplate (2).