LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Express 2500 LS, 6.0L Eng VIN G >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical - 4.3L (LV1)) >> Repair Instructions >> Oil Pan Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. For oil pan assemble, refer to Oil Pan Assemble .
  2. GM3275563Courtesy of GENERAL MOTORS COMPANY

    Apply a 3 mm (0.118 in) bead of RTV sealant on the engine front cover as shown (a). Apply a 5 mm (0.197 in) bead of RTV sealant on the engine front cover as shown (b). Adhesives, Fluids, Lubricants, and Sealers 

  3. GM4866392Courtesy of GENERAL MOTORS COMPANY

    Oil Pan (3) - Install

  4. Oil Pan Bolt (2) - Install and hand tighten [12x]
  5. Oil Pan Bolt (1) - Install and hand tighten [2x]
  6. Fig 1: Oil Pan Bolt Tightening Sequence
    GM3275565Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Fastener Caution .

    Oil Pan Bolt - tighten in sequence - Oil Pan Installation 

  7. GM4865851Courtesy of GENERAL MOTORS COMPANY

    Transmission Bolt (1) - Install [2x] - Transmission Replacement (With LV1 Engine)

  8. GM4866374Courtesy of GENERAL MOTORS COMPANY

    Wiring Harness Retainer-Left Side (1) @ Oil Pan (2) - Install [2x]

  9. GM4866108Courtesy of GENERAL MOTORS COMPANY

    Engine Wiring Harness Channel (3) - Reposition

  10. Retainer (2) - Install
  11. Engine Wiring Harness Conduit Stud (1) - Install and tighten 10 N.m (89 lb in)
  12. GM4866376Courtesy of GENERAL MOTORS COMPANY

    Wiring Harness Retainer-Right Side (1) @ Oil Pan (2) - Install [2x]

  13. GM4866349Courtesy of GENERAL MOTORS COMPANY

    Battery Negative Cable (3) - Reposition

  14. Wiring Harness Clip (2) - Install [2x]
  15. Attach the wire harness retainer at the transmission fluid cooler pipe bracket.
  16. GM4866229Courtesy of GENERAL MOTORS COMPANY

    Transmission Fluid Cooler Pipe Clip (3) - Reposition

  17. Transmission Fluid Cooler Pipe Bracket Bolt (2) - Install and tighten 9 N.m (80 lb in)
  18. Electrical Connector (1) - Connect
  19. GM4858425Courtesy of GENERAL MOTORS COMPANY

    Engine Oil Cooler Pipe @ Oil Pan - Install - Engine Oil Cooler Pipe Replacement (LV1)

  20. GM4843873Courtesy of GENERAL MOTORS COMPANY

    Starter (1) - Install - Starter Replacement (LV1)

  21. GM4865207Courtesy of GENERAL MOTORS COMPANY

    Transmission Converter Cover-Left Side (2) - Install - Transmission Converter Cover Replacement (Left Side)

  22. GM4846751Courtesy of GENERAL MOTORS COMPANY

    Front Suspension Lower Crossmember - Install - Front Suspension Crossmember Replacement

  23. Oil Level Indicator Tube- Lower - Install - Oil Level Indicator Tube Replacement (Lower) 
  24. Install a NEW oil filter. Engine Oil and Oil Filter Replacement