Removal Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Crankshaft Balancer (2) - Remove - Crankshaft Balancer Replacement
Courtesy of GENERAL MOTORS COMPANY

Water Pump (1) - Remove - Water Pump Replacement (LV1)
Oil Pan - Remove - Oil Pan Replacement
Disconnect electrical connectors as necessary.
Courtesy of GENERAL MOTORS COMPANY

Remove the harness bolts (1) and the harness (2)
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Three different bolt sizes are used in the engine front cover. Note the size and location of each bolt to ensure correct installation.

Remove the front cover bolts (1-3) [13x].
Remove front cover (4).
Clean and inspect the engine front cover. Engine Front Cover Cleaning and Inspection