Inspection Procedure
WARNING: This page is about a different variant/trim than selected.
- Inspect the following components:
- Cylinder walls for excessive scratches, gouging, or ring ridge
- Cylinder bores for excessive ring ridge at the top of the cylinder
- Coolant jacket for cracks
- Valve lifter bores for excessive scoring or wear
- Crankshaft bearing webs for cracks
- Gasket sealing surfaces for excessive scratches or gouging
Refer to Replacing Engine Gaskets .
- Oil galleries for restrictions
- Threaded bolt holes for damaged threads
- Cylinder bores for excessive ring ridge at the top of the cylinder
NOTE:Check the cylinder condition. Some light vertical marks may be visible on the cylinder wall. In these areas, check that the honing marks are still visible in this marked area. If they are, the cylinder surface has not been compromised and the engine block can be used.
- Measure the cylinder bores for an oversize condition: