Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- IMPORTANT:
For proper orientation, note the installation direction of the oil seal. The oil seal is a reverse-lip design. Install with "THIS SIDE OUT" displayed as shown.
Inspect the seal for proper orientation.
- NOTE:
- Do not lubricate the oil seal sealing surface.
- Do not use the crankshaft front oil seal again.
Install the crankshaft front oil seal (3) onto the threaded rod, nut and washer from EN-41478-A crankshaft front oil seal installer (1) and EN-51091 crankshaft front oil seal installer (2).
- Install the EN-41478-A crankshaft front oil seal installer threaded rod, nut and washer (1) and EN-51091 crankshaft front oil seal installer (2) and oil seal (3), into the end of the crankshaft.
- Use the EN-41478-A
crankshaft front oil seal installer (1) and EN-51091
crankshaft front oil seal installer (2) in order to install the oil seal (3) into the cover bore.
- Use a wrench and hold the hex on the installer bolt.
- Use a second wrench and rotate the installer nut clockwise until the seal bottoms in the cover bore.
- Remove the tool.
- Inspect the oil seal for proper installation. The oil seal should be installed evenly and completely into the front cover bore.
Crankshaft Balancer (1) - Install - Crankshaft Balancer Replacement