Installation Procedure
WARNING: This page is about a different variant/trim than selected.
Crankshaft Balancer (1) - Loosely install
Install the EN-41478 - A Crankshaft Front Oil Seal Installer (1) and the EN-41665 - A Crankshaft Balancer and Sprocket Installer (2) to the crankshaft balancer (3).
- Use the adjustment nut on the EN-41478 - A Crankshaft Front Oil Seal Installer (1) to properly seat the crankshaft balancer (3).
- Once the crankshaft balancer has been properly seated remove the EN-41478 - A Crankshaft Front Oil Seal Installer (1) and the EN-41665 - A Crankshaft Balancer and Sprocket Installer (2).
Install the EN-52287 Balancer Holding Kit (1) and the EN-956 - 1 Extension Bar (2) to the crankshaft balancer (3).
Crankshaft Balancer Bolt (1) - Install NEW - Crankshaft Balancer Installation
- Remove the special tools.
{ If equipped }Vacuum Pump Belt (3) - Install - Vacuum Pump Belt Replacement
Air Conditioning Compressor Belt (3) - Install - Air Conditioning Compressor Belt Replacement
Engine Coolant Fan Lower Shroud (1) - Install - Engine Coolant Fan Lower Shroud Replacement (LV1)
- Perform the crankshaft position variation learn. Crankshaft Position Variation Learn