Intake Manifold

The intake manifold is a 1-piece composite design that incorporates brass threaded inserts for mounting the throttle body, and wire harness studs. Each side of the intake manifold is sealed to the cylinder head by 6 silicone push in place gaskets. The electronically actuated throttle body bolts to the front of the intake manifold. The throttle body is sealed by a 1-piece push in place silicone gasket. The intake manifold covers the direct injected fuel rail assembly, fuel pipes and fuel pump. The manifold absolute pressure (MAP) sensor is installed and retained to the left front of the intake manifold behind the throttle body. The evaporative (EVAP) emission canister purge solenoid valve is mounted left front of the intake manifold below the MAP sensor.