Removal Procedure
WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the left side stationary window. Body Side Front Trim Panel Replacement - Left Side
- Remove the rear side stationary window. Body Side Rear Trim Panel Replacement
- Remove the right side stationary window. Body Side Trim Panel Replacement - Right Side
- Cover to protect the following parts from broken glass:
- The upper dash pad
- The defroster outlets and A/C outlets
- The seats
- The carpeting
- Cover to protect the following parts from broken glass:
- Upper dash pad
- Defroster outlets and A/C outlets
- Seats and carpeting
- This will allow the urethane adhesive to be separated from the window.
- Leave a base of urethane on the pinchweld flange.
- The only suitable lubrication is clear water.
- Use J 24402-A Glass Sealant Remover (cold knife),
- Use J 39032 Stationary Glass Removal Tool.
- Remove the stationary window from the pinchweld flange with the aid of an assistant.
WARNING:
If a window is cracked but still intact, crisscross the window with masking tape in order to reduce the risk of damage or personal injury.
NOTE:
Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
WARNING:
If broken glass falls into the defroster outlets, it can be blown into the passenger compartment and cause personal injury.
WARNING:
When working with any type of glass or sheet metal with exposed or rough edges, wear approved safety glasses and gloves in order to reduce the chance of personal injury.
NOTE:
Keep the cutting edge of the tool against the window.