Crankshaft Rear Oil Seal Housing Removal
WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools
- EN-50026 Rear Main Seal Installer
- GE-8092 Driver Handle
For equivalent regional tools, refer to Special Tools
Remove the crankshaft position sensor excitor ring (1) and locating pin (6).
- Remove the rear oil seal housing bolts (2) and seal housing (3).
- Remove the rear oil seal housing gasket (4).
- Remove the rear oil seal housing locating pins (5).
- NOTE:
The crankshaft rear oil seal must be driven out from the engine block side of the housing.
Remove the crankshaft rear oil seal (1) using the EN-50026 installer (2) and GE-8092 handle (3).