Installation Procedure
WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
Engine Mount (1) - Install
Clean the threads of the engine mount engine side bolts (1) using denatured alcohol or equivalent.
- Apply thread locker or equivalent to the threads of the engine mount engine side bolts (1). Adhesives, Fluids, Lubricants, and Sealers
- Engine Mount Engine Side Bolt (1) - Install and tighten [4x] 50N.m (37 lb ft)
- Using the adjustable jack, lower the engine until the engine mount is sitting flush on the frame.
- Remove the adjustable jack and block of wood from the engine oil pan.
Clean the threads of the engine mount frame side bolts (1) using denatured alcohol or equivalent.
- Apply thread locker or equivalent to the threads of the engine mount frame side bolts (1). Adhesives, Fluids, Lubricants, and Sealers
- Engine Mount Frame Side Bolt (1) - Install and tighten [3x] 70N.m (52 lb ft)
Front Suspension Crossmember (1) - Install - Front Suspension Crossmember Replacement
- Front Wheelhouse Splash Shield- Left Side - Install - Wheelhouse Splash Shield Replacement (Left Side)
- Lower the vehicle.
Air Cleaner Outlet Duct (3) - Install - Air Cleaner Outlet Duct Replacement
- Connect the battery negative cable. Battery Negative Cable Disconnection and Connection (Single Battery) , or Battery Negative Cable Disconnection and Connection (Dual Battery)
CAUTION:
Refer to Fastener Caution .