LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Express 2500 LS, 6.0L Eng VIN G >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Interior Trim And Paneling >> Repair Instructions >> Center Pillar Upper Garnish Molding Replacement - Right Side

Center Pillar Upper Garnish Molding Replacement - Right Side

GM4861740Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Disable the SIR system. SIR Disabling and Enabling
  2. Remove the front seat belt from the front seat belt height adjuster. Front Seat Belt Retractor Replacement
1 Center Pillar Upper Garnish Molding Cover [2x]
2 Center Pillar Upper Garnish Molding Screw[2x]
CAUTION:

Refer to Fastener Caution .


Tighten 
2 N.m (18 lb in)
3 Center Pillar Upper Garnish Molding-Right Side

Procedure

  1. Pull the trim panel toward the inside of the vehicle to disengage the retainers and to clear the front seat belt assembly.
  2. When replacing the center pillar upper garnish molding, feed the seat belt through the panel.
  3. Ensure the seat belt webbing does not become trapped during installation.
  4. Enable the SIR System. SIR Disabling and Enabling
scientia non olet · About LEMON Manuals