Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Assemble the cylinder head as necessary. Cylinder Head Assemble
Ensure the cylinder head locating pins (5) are securely mounted in the cylinder block deck face.
- Install a NEW right cylinder head gasket (4) using the deck face locating pins for retention.
- Cylinder Head Assembly (3) - Install - Cylinder Head Installation - Right Side
Camshaft Carrier - Right Side (2) - Install - Camshaft Carrier Installation - Right Side
- Camshaft-Right Side - Install - Camshaft Installation - Right Side
- Position wire harness and connect as necessary.
- Install ground wire and ground wire bolt. Tighten bolt to 15 N.m (11 lb ft).
- Fuel Pump - Install - Fuel Pump Replacement
Warm Up Three-Way Catalytic Converter (3) @Bank 1 - Install - Warm Up Three-Way Catalytic Converter Replacement (LH - LGX) , or Warm Up Three-Way Catalytic Converter Replacement (RH - LGX)
Fuel Injection Fuel Rail Noise Shield (1) - Install - Fuel Injection Fuel Rail Noise Shield Replacement
- Camshaft Timing Chain-Right Side - Install - Camshaft Timing Chain Assembly Replacement - Right Side