Cylinder Head Installation - Right Side
| Callout | Component Name |
|---|---|
| 1 | Fuel Injection Fuel Rail Noise Shield
WARNING:
The noise cancelling foam component MUST be replaced if it has been exposed to engine fluids. Failure to replace the noise cancelling foam component that has been exposed to engine fluids may result in an engine fire resulting in catastrophic engine damage, and possible injury or death. |
| 2 | Cylinder Head Gasket Procedure Install a NEW gasket. |
| 3 | Cylinder Head |
| 4 | Cylinder Head Bolt M11 x 178 [8x]
CAUTION:
Refer to Fastener Caution .
CAUTION:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component. Procedure Install NEW bolts. Do NOT reuse old bolts. Tighten in sequence
Special Tools EN - 45059 Angle Meter Equivalent regional tools: Special Tools |
| 5 | Cylinder Head Bolt M8 x 80.8
CAUTION:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component. Procedure Install NEW bolts. Do NOT reuse old bolts. Tighten in sequence
|