Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Assemble the camshaft cover as needed. Camshaft Cover Assemble .
-
Courtesy of GENERAL MOTORS COMPANY
Place a bead 8 mm (0.3150 in) in width by 4 mm (0.1575 in) in height of RTV sealant equivalent, on the engine front cover split lines (1). Adhesives, Fluids, Lubricants, and Sealers
- Camshaft Cover Seal (2) - Install
- Camshaft Cover (3) - Install
- Camshaft Cover Bolt (4) - Loosely install [18x]
- Camshaft Cover Bolt (4) - Tighten [18x] 15 N.m (11 lb ft)
Position the fuel feed pipe and install the fuel feed pipe bolt (1). Fuel Feed Pipe Replacement (LGX at Engine) , or Fuel Feed Pipe Replacement (Fuel Tank To Engine LGX)
- Position and install the engine harness to the camshaft cover.
- Camshaft Position Actuator Valve Solenoid Replacement - Bank 1 (Right Side) Intake - Install
- Camshaft Position Actuator Valve Solenoid Replacement - Bank 1 (Right Side) Exhaust - Install
- Ignition Coil Replacement - Bank 1 - Install
- Positive Crankcase Ventilation Tube@Camshaft Cover - Connect
- Camshaft Housing Cover Insulator Replacement - Right Side - Install
NOTE:
Install a NEW seal.
CAUTION:
Refer to Fastener Caution .
NOTE:
Tighten in the sequence shown.