Camshaft Position Actuator Valve Solenoid Replacement - Bank 1 (Right Side) Intake

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Camshaft Housing Cover Insulator Replacement - Right Side
1	Camshaft Position Actuator Solenoid Valve Bolt CAUTION: Refer to Fastener Caution . Tighten 10 N.m (89 lb in)
2	Camshaft Position Actuator Solenoid Valve
3	O-Ring NOTE: Install a NEW O-ring seal. NOTE: Lubricate the NEW O-ring seals with clean engine oil.
4	Camshaft Position Actuator Solenoid Valve Seal NOTE: Always install the camshaft position actuator solenoid valve seal supplied with the NEW camshaft position actuator solenoid valve. If reinstalling the valve, inspect the camshaft position actuator solenoid valve seal and replace as necessary.