Installation Procedure
WARNING: This page is about a different variant/trim than selected.
Position the NEW bearing to the rear of the crankshaft.
- Assemble the GE - 8433
two jaw puller (2), the EN - 45949
pilot bearing and flywheel locator installer (1) and bolts to the rear of the crankshaft.
Tighten the bolts until snug.
- Rotate the bolt of the GE - 8433 two jaw puller (2) until the bearing is seated in the bore of the crankshaft.
- Remove the tools.
Inspect the clutch pilot bearing for proper installation.
- Install the transmission to the vehicle. Transmission Replacement (MM6 with LT1 Engine, MH3 or MJK with LT4 Engine)