Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

Position the clutch slave cylinder (2) on the transmission.
Install the clutch slave cylinder and bolts (1) and tighten to 9 N.m (80 lb in).
Install the manual transmission to the vehicle. Refer to Transmission Replacement (MM6 with LT1 Engine, MH3 or MJK with LT4 Engine) , or Transmission Replacement (M13 with LGX Engine) , or Transmission Replacement (M13 with LTG Engine) .