LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Camaro SS, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (M/T Clutch) >> Diagnostic Information and Procedures >> Clutch Rattle

Clutch Rattle

WARNING: This page is about a different variant/trim than selected.
Cause Action
DEFINITION: A rattle noise coming from the clutch components with the clutch disengaged or engaged.
Review the Symptoms - Clutch  and perform the necessary inspections.
Idle rattle clutch engaged Replace the clutch disc, due to faulty damper springs. Refer to Clutch Assembly Replacement (M13 Transmission) , or Clutch Assembly Replacement (MJK, MH3, MM6) .
Clutch is improperly installed Remove the clutch and install it correctly. Refer to Clutch Assembly Replacement (M13 Transmission) , or Clutch Assembly Replacement (MJK, MH3, MM6) .
Clutch disc damper worn or damaged
  1. Inspect the clutch disc for a broken or worn damper.
  2. Replace the clutch assembly. Refer to Clutch Assembly Replacement (M13 Transmission) , or Clutch Assembly Replacement (MJK, MH3, MM6) .
Clutch disc splines and input shaft splines worn
  1. Inspect the clutch disc hub to input shaft splines for excessive clearance.
  2. Replace the clutch assembly if the clutch splines are worn. Refer to Clutch Assembly Replacement (M13 Transmission) , or Clutch Assembly Replacement (MJK, MH3, MM6) .
  3. Replace the input shaft. Refer to Transmission Disassemble (M13 - LGX with Y4Q) , or Transmission Disassemble (MJK, MH3, or MM6) , or Transmission Disassemble (M13 - LGX without Y4Q, LTG) .