LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Camaro SS, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Engine Mechanical - 2.0L (LTG) - Repair Instructions) >> Repair Instructions >> Turbocharger Oil Feed Pipe Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM4574832Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Install a NEW gasket.

    Turbocharger Oil Feed Pipe Gasket (3) - Install

  2. Turbocharger Oil Feed Pipe (2) - Install
    3. CAUTION:

    Refer to Fastener Caution .

  3. Turbocharger Oil Feed Pipe Bolt (1) - Install and tighten [2x] 10 N.m (89 lb in)
  4. Turbocharger - Install - Compressor Air Intake Turbocharger Replacement 
  5. Fig 1: Turbocharger Oil Feed Pipe Bolt And Sealing Washers
    GM4241615Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Install NEW sealing washers.

    Turbocharger Oil Feed Pipe Washer (2) - Install [2x]

  6. Turbocharger Oil Feed Pipe Bolt (1) - Install and tighten 35 N.m (26 lb ft)
  7. Engine Mount Bracket-Left Side - Install - Engine Mount Bracket Replacement - Left Side 
scientia non olet · About LEMON Manuals