Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Remove the drive belt. Drive Belt Replacement
Use EN-51577-1 Crankshaft Balancer Remover (1) and breaker bar (2) to prevent the crankshaft from rotating while loosening the crankshaft balancer fastener (3).
- Remove and DISCARD the crankshaft balancer fastener (3).
Remove the crankshaft balancer holder then install the J-41816-2 or EN-38416-2 Crankshaft End Protector (1) and all components of EN-51577 Crankshaft Balancer Remover (2, 3) as shown.
Tighten the crankshaft balancer remover (1) in order to remove the crankshaft balancer (2).
- Remove the EN-51577-1 Crankshaft Balancer Remover from the crankshaft balancer.
- Remove the J-41816-2 or EN-38416-2 Crankshaft End Protector.