LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Camaro SS, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Engine Mechanical - 2.0L (LTG) - Repair Instructions) >> Repair Instructions >> Crankshaft Balancer Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM3971349Courtesy of GENERAL MOTORS COMPANY

    Install the crankshaft balancer with NEW fastener. Use EN-51577-1  Crankshaft Balancer Remover (1) and ratchet (2) prevent the crankshaft from rotating while tightening the NEW crankshaft balancer fastener (3).

    2. CAUTION:

    Refer to Fastener Caution .

  2. Tighten the crankshaft balancer bolt to 150 N.m (111 lb ft) plus an additional 140 degrees using the EN-45059  meter.
  3. Install the drive belt. Drive Belt Replacement .
scientia non olet · About LEMON Manuals