Removal Procedure
WARNING: This page is about a different car, the 2019 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
- Open the hood.
- Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
- Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement (L5Q) , or Air Cleaner Outlet Duct Replacement (LV7) .
- Disconnect the fuel injector connectors. Refer to Fuel Injection Fuel Rail Assembly Replacement (L5Q) , or Fuel Injection Fuel Rail Assembly Replacement (LV7) .
- Disconnect the any electrical connectors to set aside the engine main control wiring harness from camshaft cover.
- Remove the ignition coil. Refer to Ignition Coil Replacement , or Ignition Coil Replacement (LV7) .
- Remove the camshaft position sensor. Refer to Camshaft Position Sensor Replacement , or Camshaft Position Sensor Replacement (LV7) .
- Remove the camshaft position actuator solenoid valve. Refer to Camshaft Position Actuator Solenoid Valve Replacement , or Camshaft Position Actuator Solenoid Valve Replacement (LV7) .
Remove the engine lift front bracket (1), engine cover bracket (2), engine lift rear bracket (3) and engine pressure oxygen sensor bracket (4).
- Remove the vacuum pump. Refer to Vacuum Pump Assembly Replacement , or Vacuum Pump Assembly Replacement (LV7) .
- Remove the oil level indicator. Refer to Oil Level Indicator Replacement , or Oil Level Indicator Replacement (LV7) .
Remove the ball stud (1) from the camshaft cover.
Remove the 4 camshaft cover stud bolts (1).
- Remove the 13 camshaft cover bolts (2).
- Remove the camshaft cover (3).
Remove the camshaft cover gasket (1).