Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition - On/Vehicle - In Service Mode
- Verify the scan tool parameter: Water in Fuel = No
- If not the specified state
- Verify the condition does not exist: Water @ Fuel Filter Water Bleed Screw
Refer to: Water-in-Fuel Draining
- If a condition exists - Refer to: Contaminants-in-Fuel Diagnosis
- If no condition exists - Refer to: Circuit/System Testing
- Go to next step: If the specified state
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Refer to: Circuit/System Testing
- Go to next step: If the DTC is not set
- If the DTC sets
- All OK.