Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

NOTE:
The graphic is shown without the exhaust front pipe, for the sake of clarity.

Right Front Wheel Drive Shaft Seal (1) - Install NEW - Use the special tool: DT-47790 installer (2) & DT-8092 handle (3)
Right Front Wheel Drive Shaft - Install - Front Wheel Drive Shaft Replacement
Check the transmission fluid level. Transmission Fluid Drain and Fill
Remove the container under the right front wheel drive shaft oil seal.
Front Compartment Insulator - Install - Front Compartment Insulator Replacement
Lower the vehicle.