Removal Procedure

WARNING: This page is about a different variant/trim than selected.

Remove the timing chain upper cover. Refer to Timing Chain Upper Cover Replacement
Remove the crankshaft pulley. Refer to Crankshaft Pulley Replacement .
Courtesy of GENERAL MOTORS COMPANY

Install the 4 crankshaft pulley bolts (1).
Courtesy of GENERAL MOTORS COMPANY

NOTE:
If the bores not aligned turn the crankshaft at the crankshaft pulley bolts.

Check if the bores (1) are aligned.

Courtesy of GENERAL MOTORS COMPANY

Turn the exhaust camshaft at the hexagon so far if the EN-51143 fixing tool (1) can be installed.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
Courtesy of GENERAL MOTORS COMPANY

Remove the 4 crankshaft pulley bolts (1).
Courtesy of GENERAL MOTORS COMPANY

Install EN-51140 fixing tool (2).
Install the fixing pin into the engine block bore (1) and tighten the 2 bolts (3).
If the EN-51140 fixing tool can not installed. Refer to Camshaft Timing Chain Adjustment .
Lower the vehicle.
Courtesy of GENERAL MOTORS COMPANY

Tension the timing chain tensioner (1) in arrow direction.
Install the EN-50513 pin (2).
Courtesy of GENERAL MOTORS COMPANY

Remove the 2 timing chain tensioner bolts (3).

NOTE:

If the timing chain tensioner reused, do not remove the EN-50513 pin (2).