LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2019 >> Cruze Premier, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 1.6L (LH7) Diesel) >> Repair Instructions - On Vehicle >> Timing Chain Lower Cover Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Timing Chain Upper Cover - Remove - Timing Chain Upper Cover Replacement .
  2. Oil Pan - Remove - Oil Pan Replacement (Automatic Transmission) .
  3. GM4421926Courtesy of GENERAL MOTORS COMPANY

    Engine Lift Bracket-Left Side (1) - Install

    4. CAUTION:

    Fastener Caution

  4. Engine Lift Bracket Bolt (2) - Install and tighten 58 N.m (43 lb ft)
  5. GM4421927Courtesy of GENERAL MOTORS COMPANY

    Engine Lift Bracket-Right Side (1) - Install

  6. Engine Lift Bracket Bolt (2) - Install and tighten 58 N.m (43 lb ft).
  7. Crankshaft Position Reluctor Ring - Remove - Crankshaft Position Sensor Reluctor Ring Replacement (Automatic Transmission) .
  8. GM4421925Courtesy of GENERAL MOTORS COMPANY

    Crankshaft Position Sensor Bolt (1) - Remove

  9. Remove the crankshaft position sensor retainer spring (3).
  10. Crankshaft Position Sensor (2) - Remove
  11. GM4421928Courtesy of GENERAL MOTORS COMPANY

    Remove the 11 timing chain lower cover bolts (1).

  12. Timing Chain Lower Cover (2) - Remove - Use a suitable tool.
  13. Remove and DISCARD the gasket. (3) [2x]
  14. Remove the crankshaft rear oil seal, if the timing chain lower cover reused.
scientia non olet · About LEMON Manuals