LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2019 >> Cruze Premier, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 1.6L (LH7) Diesel) >> Repair Instructions - On Vehicle >> Oil and Power Brake Booster Pump Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the oil pan. Refer to Oil Pan Replacement (Automatic Transmission) .
  2. GM3275444Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    For a better overview in the graphic the transmission is not shown.

    Tension the oil pump drive chain tensioner (3) with the EN-51142-2  holding tool (2) in arrow direction.

  3. Install the oil pan bolt (1) to fix the EN-51142-2  holding tool.
  4. GM3275445Courtesy of GENERAL MOTORS COMPANY

    Install the EN-51142-1  holding tool (1) to oil pump sprocket.

  5. Loosen the oil pump sprocket bolt (2) by counterhold at the EN-51142-1  holding tool.
  6. GM3275446Courtesy of GENERAL MOTORS COMPANY

    Unscrew the oil pump sprocket bolt (1) as far as possible.

  7. Detach the oil pump sprocket (2) from the oil and power brake booster pump shaft, use a suitable tool.
  8. GM3275447Courtesy of GENERAL MOTORS COMPANY

    Remove the 4 oil pump bolts (5).

  9. Remove the oil and power brake booster pump (4).
  10. Remove and DISCARD the oil pump sprocket bolt (3) from the oil pump sprocket (2).
  11. Remove the 2 oil and power brake booster pump gaskets (1).
scientia non olet · About LEMON Manuals