Removal Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Remove the 2 EN-51007-6 adapters (1) from the 2 engine lift brackets (2).
Courtesy of GENERAL MOTORS COMPANY

Loosen the 2 EN-51007-4 adapters (3).

NOTE:

A second technician is required.

Remove the 2 EN-51007-3 adapters (4) with the EN-51007-5 adapters (6) from the EN-51007-1 adapter (1).
Courtesy of GENERAL MOTORS COMPANY

Remove the EN-51007-1 adapter (3).
Clean the contact surfaces from the EN-51007-5 adapters on the front end upper tie bar with solvent.