Assemble EN-51007 Engine Support Fixture

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

NOTE:
Pre-assemble special tool assembly outside the vehicle.

Install the lower foot (2) to the upper foot (1).
Install the mounting bolt (5).
Install the adjustment screw (4) and tighten the 2 nuts (3).
Courtesy of GENERAL MOTORS COMPANY

Install the 2 EN-51007-7 or EN-51007-10 adapters (2) to the EN-51007-1 adapter (1).
Tighten the adjustment screw (3).
Courtesy of GENERAL MOTORS COMPANY

Install the 2 EN-51007-4 adapters to the EN-51007-1 adapter by guiding the bail (4) into the board (1).
Install the 2 thumb nuts (2).
Courtesy of GENERAL MOTORS COMPANY

Install the bushing (1) to the hook (3).
Install the lever (2) to the hook (3).
Courtesy of GENERAL MOTORS COMPANY

Install the EN-51007-6 adapters (1) to the EN-51007-3 adapters (2).
Courtesy of GENERAL MOTORS COMPANY

Install the foot (4) to the rod (2)
Install and tighten the bolt (5) and the nut (3).
Install the bolt (1).
Courtesy of GENERAL MOTORS COMPANY

NOTE:
The feet should stay in the second hole of the rakes.

Install EN-51007-5 adapter (3) to the EN-51007-3 adapter (1).
Install the cotter pin (4) into the bolt (2).
Courtesy of GENERAL MOTORS COMPANY

NOTE:
The distance (a) must be aligned to 1400 mm (55 in).

Check the distance between the 2 feet (3).
Tighten the 2 adjustment screws (1, 2).