Engine Block Disassemble
WARNING: This page is about a different variant/trim than selected.
Remove the 2 cylinder head guide sleeves (1).
Engine Oil Pressure Switch (1) - Remove
- Engine Coolant Temperature Sensor (3) - Remove
- Remove the 2 piston oil nozzle oil control solenoid valve bolts (2).
- Remove the piston oil nozzle oil control solenoid valve (4).
- Engine Oil Pressure Sensor (5) - Remove
Engine Block Core Hole Plug (1) - Remove and DISCARD
- Engine Block Coolant Drain Hole Plug (2) - Remove
- Engine Block Oil Gallery Plug (3) - Remove [4x]
Engine Block Core Hole Plug (1) - Remove and DISCARD [3x]
Catalytic Converter Stud (4) - Remove
- Engine Block Core Hole Plug (1) - Remove and DISCARD
- Engine Block Coolant Drain Hole Plug (2) - Remove
- Engine Block Oil Gallery Plug (3) - Remove
Piston Oil Nozzle Bolt (3) - Remove [4x]
- Piston Oil Nozzle (2) - Remove [4x]
- Remove the 10 lower crankcase guide sleeves (1).