Cylinder Head Removal

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Remove the bearing bracket (1).
Courtesy of GENERAL MOTORS COMPANY

Remove and DISCARD the 2 outer cylinder head bolts (1).
Fig 1: Identifying Cylinder Head Bolts With Loosening Sequence
Courtesy of GENERAL MOTORS COMPANY

Loosen the 10 cylinder head bolts in sequence as shown.
Courtesy of GENERAL MOTORS COMPANY

Remove and DISCARD the 10 cylinder head bolts (1).

NOTE:

Ensure the guide sleeves (3) are properly seated in the engine block.