Charge Air Bypass Regulator Solenoid Valve Vacuum Tube Installation
WARNING: This page is about a different variant/trim than selected.
Install a new charge bypass valve vacuum hose seal (3).
- Install the charge bypass valve vacuum hose (1).
- Clip the charge bypass valve vacuum hose (1) into the retainer clip.
- Connect the charge bypass valve vacuum hose (1) to the exhaust gas recirculation vacuum regulator solenoid valve.
- Install the 2 charger bypass valve vacuum hose bracket bolts (2, 5) and tighten to 10 N.m (89 lb in).
- Install the charger bypass valve vacuum hose bracket bolt (4) and tighten to 10 N.m (89 lb in).
CAUTION:
Refer to Fastener Caution .