Camshaft Housing Installation

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Camshaft Housing Gasket (5) @ Camshaft Housing (4) - Install NEW
Camshaft Housing Bolt (2) @ Camshaft Housing (4) - Install [20x]
Inspect the correct seat of the camshaft housing bolt bushings (3) and the camshaft housing cover insulators (1).
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Mind the different bolts.

Install the camshaft housing cover (3) along with the camshaft housing gasket (5) and the 20 camshaft housing bolts (1, 2, 4).
Camshaft Housing Bolt (1, 2, 4) - Hand tighten [20x]
Fig 1: Identifying Camshaft Housing Bolts With Tightening Sequence
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Fastener Caution

Camshaft Housing Bolt - Tighten in sequence [20x] 10 N.m (89 lb in)
Courtesy of GENERAL MOTORS COMPANY

Engine Oil Level Indicator (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Engine Lift Bracket (2) - Install
Engine Lift Bracket Bolt (1) - Install and tighten 58 N.m (43 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Engine Lift Bracket (1) - Install [2x]
Engine Lift Bracket Bolt (2) - Install and tighten [2x] 58 N.m (43 lb ft)