Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- NOTE:
To aid in hand starting glow plugs into their bores, a hose or tube with an inner diameter of 4 mm can be used as an extension when installed on the end of the glow plug
CAUTION:Install the 4 glow plugs (1) and tighten to 16.5 N.m (12 lb ft), using the EN-6104 socket.
Glow Plug Electrical Connector (1) @ Glow Plug - Connect [4x]
- Engine Sight Shield Replacement - Install
- Battery Negative Cable Disconnection and Connection - Connect