Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Fuel Tank Filler Pipe @ Vehicle - Install
Fuel Tank Filler Pipe (2) @ Fuel Tank Filler Hose (4) - Install
- Clamp (3) - Install and tighten 3.5 N.m (31 lb in)
- Fuel Tank Vent Pipe (1) - Connect - Plastic Collar Quick Connect Fitting Service
Fuel Tank Filler Pipe Ground Bolt (2) - Install and tighten 22 N.m (16 lb ft)
Fuel Tank Filler Pipe Bolt (1) - Install and tighten 9 N.m (80 lb in)
- Fuel Tank Filler Pipe Housing - Install - Fuel Tank Filler Pipe Housing Removal and Installation
- Rear Wheelhouse Liner-Right Side - Install - Rear Wheelhouse Liner Replacement
- Connect the battery negative cable. Battery Negative Cable Disconnection and Connection
CAUTION: