Installation Procedure
WARNING: This page is about a different variant/trim than selected.
Fuel Injection Fuel Feed Pipe (1) - Install NEW [4x]
- Fuel Injection Fuel Feed Pipe (1) @ Fuel Injector (2) - Hand tighten [4x]
- Fuel Injection Fuel Feed Pipe (1) @ Fuel Injection Fuel Rail (3) - Hand tighten [4x]
- Fuel Injection Fuel Feed Pipe (1) - Tighten [8x] 28 N.m (21 lb ft)
Fuel Injector Insulator (1) - Install
- Fuel Return Hose (4) @ Diesel Fuel Separator (2) - Connect
- Install a NEW clamp. (3)
- Install the engine sight shield. Engine Sight Shield Replacement
- Connect the battery negative cable. Battery Negative Cable Disconnection and Connection
CAUTION: