Removal Procedure
WARNING: This page is about a different variant/trim than selected.
WARNING:
WARNING:
CAUTION:
Clean all fuel pipe and hose connections and surrounding areas before disassembling to avoid possible contamination of the fuel system. Spray the fuel pump module cam-lock ring tang with penetrating oil prior to attempting removal.
- Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
- Remove the engine sight shield. Engine Sight Shield Replacement
Fuel Injection Fuel Feed Pipe Bracket Bolt (1) - Remove
- Fuel Injection Fuel Feed Pipe (2) @ Fuel Rail (3) - Loosen
- Fuel Injection Fuel Feed Pipe (2) @ Fuel Injection Pump (4) - Loosen
- Fuel Injection Fuel Feed Pipe (2) - Remove and DISCARD
- Close the fuel rail using suitable closure plugs.
NOTE:
Counterhold at the fuel injection pump hexagon connector.