Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Install the fuel feed pipe-underbody to the vehicle.
Remove the closure plugs from all connections.
- Connect the fuel feed pipe-underbody (2) to the fuel feed pipe - fuel pump module to underbody (1). Plastic Collar Quick Connect Fitting Service .
Install the fuel feed pipe-underbody (1) to the 4 retainer clips (2).
- Retainer Clip (2) - Close [4x]
Install the fuel feed pipe-underbody (2) to the bulkhead clip (1).
- Bulkhead Clip (1) - Close
Fuel Feed Pipe (2) @ Bulkhead Clip (1) - Install
- Bulkhead Clip (1) - Close
- Lower the vehicle.
Clip (2) - Install
- Remove the closure plugs from all connections.
- Fuel Feed Front Pipe (2) @ Fuel Feed Pipe (3) - Connect - Metal Collar Quick Connect Fitting Service
- Install the engine sight shield. Engine Sight Shield Replacement
- Connect the battery negative cable. Battery Negative Cable Disconnection and Connection