Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Before performing the first steps, review the Emission Reduction Fluid and Emission Reduction Fluid Handling .
- Rear Wheelhouse Liner-Right Side - Remove - Rear Wheelhouse Liner Replacement
Disconnect the 2 emission reduction opening filler quick connectors (2) from the emission reduction fluid tank (1). Plastic Collar Quick Connect Fitting Service
Clip (2) - Remove
- Remove the emission reduction fluid shield door (1).
-
Courtesy of GENERAL MOTORS COMPANY
Disconnect the electrical connector:
- Emission Reduction Fluid Controller (5)
- Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe Electrical Connector (2)
- Wiring Harness (3) @ Clip (4) - Unclip
- Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe (1) - Disconnect
- Close the emission reduction fluid exhaust front pipe injector supply pipe (1) with a suitable tool.
- Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe (1) @ Clip (6, 7) - Unclip [2x]
Clip (2) - Remove [3x]
- Emission Reduction Fluid Tank Shield (1) - Remove
Support the emission reduction fluid tank (2) with a suitable jack.
- Emission Reduction Fluid Tank Bolt (3) - Remove [3x]
- Emission Reduction Fluid Tank Nut (1) - Remove [2x]
- Lower the jack along with the emission reduction fluid tank (2).
- Remove the emission reduction fluid tank (2) from the jack.
- Pour out the emission reduction fuel tank.
- Put the emission reduction fluid tank on a workbench.
NOTE:
A second technician is required.