Installation Procedure
WARNING: This page is about a different variant/trim than selected.
Emission Reduction Fluid Tank (2) - Install
- Support the emission reduction fluid tank (1) with a suitable jack.
- Emission Reduction Fluid Tank Nut (1) - Install and tighten [2x] 22 N.m (16 lb ft)
- Emission Reduction Fluid Tank Bolt (3) - Install and tighten [3x] 22 N.m (16 lb ft)
Emission Reduction Fluid Tank Shield (1) - Install
- Clip (2) - Install [3x]
-
Courtesy of GENERAL MOTORS COMPANY
Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe (1) @ Clip (6, 7) - Install [2x]
- Remove the tightness tool from the emission reduction fluid exhaust front pipe injector supply pipe (1).
- Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe (1) - Connect
- Wiring Harness (3) @ Clip (4) - Install
- Connect the electrical connector:
- Emission Reduction Fluid Controller (5)
- Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe Electrical Connector (2)
Install the emission reduction fluid shield door (1).
- Clip (2) - Install
Connect the 2 emission reduction opening filler quick connectors (2) to the emission reduction fluid tank (1). Plastic Collar Quick Connect Fitting Service
- Rear Wheelhouse Liner-Right Side - Install - Rear Wheelhouse Liner Replacement
- Lower the vehicle.
- Refill the emission reduction fluid tank with NEW emission reduction fluid with a minimum of 5 liters (5.28 quarts).
- When the replacement is completed, use a scan tool to perform the appropriate reset functions. Reductant Fluid Tank Level Reset
- If replacing, reprogram the module. Control Module References
NOTE:
The drained emission reduction fluid should not be re-used.