Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Before performing the first steps, review the Emission Reduction Fluid and Emission Reduction Fluid Handling .
- Rear Wheelhouse Liner - Right Side - Remove - Rear Wheelhouse Liner Replacement
Disconnect the 2 emission reduction opening filler quick connectors (2) from the emission reduction fluid tank (1). Plastic Collar Quick Connect Fitting Service
Clip (2) - Remove
- Remove the emission reduction fluid shield door (1).
Disconnect the electrical connector:
- Emission Reduction Fluid Controller (3)
- Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe Electrical Connector (4)
- Wiring Harness (2) @ Wiring Harness Retainer (1) - Unclip
- Wiring Harness (2) - Position aside
- Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe (6) @ Emission Reduction Fluid Supply Pump Module (5) - Disconnect
- Close all open connections with the suitable closure plugs.
Plastic Nut (1, 3) - Remove [4x]
- Emission Reduction Fluid Tank Shield (2) - Remove
Disconnect the electrical connector. (1)
- Emission Reduction Fluid Controller Bolt (3) - Remove [3x]
- Emission Reduction Fluid Controller (2) - Remove
Disconnect the electrical connectors. (2) [2x]
- Wiring Harness (1) - Remove
Wiring Harness (1) - Unclip [5x]
Support the emission reduction fluid tank (1) with a suitable jack.
- Emission Reduction Fluid Tank Bolt (3) - Remove [2x]
- Emission Reduction Fluid Tank Nut (2) - Remove [2x]
- Lower the jack along with the emission reduction fluid tank (2).
- Remove the emission reduction fluid tank (2) from the jack.
- Pour out the emission reduction fuel tank.
NOTE:
A second technician is required.