LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2019 >> Cruze Premier, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls And Fuel - 1.6L (LH7) Diesel - Repair Instructions) >> Repair Instructions >> Camshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM4328734Courtesy of GENERAL MOTORS COMPANY

    Camshaft Position Sensor (1) - Install

    2. CAUTION:

    Fastener Caution

  2. Camshaft Position Sensor Bolt (2) - Install and tighten 10 N.m (89 lb in)
  3. GM4328733Courtesy of GENERAL MOTORS COMPANY

    Connect the electrical connector:

    1. Fuel Injection Fuel Rail Fuel Pressure Sensor (1)
    2. Camshaft Position Sensor (2)
  4. Install the engine sight shield. Engine Sight Shield Replacement
  5. Connect the battery negative cable. Battery Negative Cable Disconnection and Connection
scientia non olet · About LEMON Manuals