Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, 2018 Chevrolet Suburban, and 2018 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.
- Install the fuel fill hose (1) to the fuel tank. Ensure that the notch in the hose is aligned with the notch on the fuel tank.
- Tighten the fuel fill hose clamp (6). 4 N.m (35 lb in).
- Install the fuel fill pipe bracket bolts (2, 4). Tighten to 12 N.m (106 lb in).
- Connect the fuel fill hose vent line quick connect fitting (3) to the EVAP canister vent solenoid valve. Refer to Plastic Collar Quick Connect Fitting Service .
- Connect the fuel fill pipe vent line to the fuel tank quick connect fitting (5). Refer to Plastic Collar Quick Connect Fitting Service .
- Install Automatic Level Control Air Compressor Inlet Tube Automatic Level Control Air Compressor Inlet Tube Replacement
- Install the rear axle vent hose clip (1) to the fill pipe.
- Lower the vehicle.
- Install Fuel Tank Filler Pipe Bracket Bolt (2) @Fuel Tank Filler Pipe (1). Tighten to 10 N.m (89 lb in).
- Install the spare tire, if necessary.
- Install the fuel fill cap, if necessary.
- Install Fuel Tank Filler Pipe Housing - Fuel Tank Filler Pipe Housing Replacement
- Install Rear Bumper Fascia - Rear Bumper Fascia Replacement (Chevrolet, GMC)Rear Bumper Fascia Replacement (Cadillac)
CAUTION:
Refer to Fastener Caution .