Camshaft Position Actuator Solenoid Valve Replacement
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, 2018 Chevrolet Suburban, and 2018 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| Preliminary Procedure Remove the camshaft position actuator-Magnet. Refer to Camshaft Position Actuator Magnet Replacement . |
|
| 1 | Camshaft Position Actuator Solenoid Valve
CAUTION:
Refer to Component Fastener Tightening Caution .
CAUTION:
The camshaft position actuator solenoid valves must be kept parallel to the engine front cover during removal and installation. The camshaft position actuator solenoid valves can be damaged if they become wedged or stuck during this process.
NOTE:
It is possible to push the camshaft rearward when installing the CMP actuator Valve. Please be careful not to push the camshaft while installing the CMP actuator valve.
NOTE:
The CPA solenoid valve must be Discarded and replaced with a NEW valve. Tighten
Special Tools J 45059 Angle Meter For equivalent regional tools, refer to Special Tools . |