Manual Shift Detent Lever With Shaft Position Switch Assembly And Park Pawl Actuator Removal
WARNING: This page is about a different car, the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, 2018 Cadillac Escalade ESV, and 2018 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Manual Shift Shaft Pin Procedure Remove and DISCARD, pin is not reusable. |
| 2 | Manual Shift Shaft |
| 3 | Automatic Transmission Manual Shift Shaft Position Switch |
| 4 | Park Pawl Actuator Assembly |
| 5 | Park Pawl Actuator Guide Pin Procedure Remove and DISCARD, pin is not reusable. |
| 6 | Park Pawl Actuator Guide Assembly Procedure Push the park pawl away from the park pawl actuator guide to remove the guide from case. |
| 7 | Manual Shift Shaft Detent Lever Bolt |
| 8 | Manual Shift Shaft Detent Lever Spring Assembly |
| 9 | Transmission Fluid Cooler Pipe Fitting Seal Procedure DISCARD the seals. Special Tools J-45201-3 Cooler Line Seal Remover Equivalent regional tools:Special Tools |