Manual Shift Detent Lever With Shaft Position Switch Assembly And Park Pawl Actuator Installation

WARNING: This page is about a different car, the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, 2018 Cadillac Escalade ESV, and 2018 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Manual Shift Detent Lever with Shaft Position Switch Assembly and Park Pawl Actuator

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Transmission Fluid Cooler Pipe Fitting Seal Procedure Install NEW seals. Special Tools DT-47770 Seal Installer Equivalent regional tools:Special Tools
2	Manual Shift Shaft Detent Lever Spring Assembly
3	Manual Shift Shaft Detent Lever Bolt CAUTION: Refer to Fastener Caution . Tighten 9 N.m (80 lb in)
4	Park Pawl Actuator Guide Assembly Procedure Push the park pawl away from the park pawl actuator guide, then install the guide into the case.
5	Park Pawl Actuator Guide Pin CAUTION: Refer to Pin Reuse Caution . Procedure Install the pin to a height of 5 mm (0.19 in).
6	Park Pawl Actuator Assembly
7	Automatic Transmission Manual Shift Shaft Position Switch
8	Manual Shift Shaft
9	Manual Shift Shaft Pin CAUTION: Refer to Pin Reuse Caution . Procedure Use a NEW pin. Install the pin so equal amounts stick out from either side of the manual shaft.